Olympia SM2/SM3/SM4 Typewriter Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Feet for the Olympia SM2, SM3, and SM4 typewriters.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Feet for the Olympia SM2, SM3, and SM4. Comes in two variants for you to choose from, one of which has the alignment nubs like the original feet. Not saying one is better than the other, but wanted to give people the option.
Printing:
- If you use the foot file that has the alignment nubs, you must print it on one of the long sides so that the face with the nubs isn't on the bed. The layer lines will be at an odd angle, visually, to the desk when installed on your typewriter but it still works perfectly fine.
- If you use the one without the nubs, print as you normally would.
Material/Filament:
- Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be soft enough. If you use too high of a hardness the surface that touches the desk will not be pliable enough and will skate around a lot easier. I did a test print with 90A and it wasn't ideal, but maybe if you do low enough infill it can be pliable enough but 100% infill on 75A is a great sweet spot that.
Feel free to print for sale, but I ask that you make pricing reasonable as that is why I went through the effort to model these.