Atorch DL24MP 300W Electronic Load Case (MM version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for Atorch DL24MP 300/2x150W and DL24B-XSP16 (ATORCH Type-C PD3.1 and Fast Charging Protocol Test Board)
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 531
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Key differences of the design:
- better mount points for banana 4mm and DC 55 power sockets
- mounting for DL24B-XSP16 Test Board
- a switch to disconnect Test Board and enable true 4 wires connection
The housing was made as compact as possible and the 4 banana sockets were replaced with internal version to reduce the space occupied by the device.
DL24B-XSP16 is "must have" for testing of modern PSUs and power banks (possibility to trigger 9V, 12V and other modes). However, the board has shorted I and U contacts, in the both positive and negative groups. This is why I need a hardware switch to disconnect the board from DL24MP input e.g. to use kelvin clamps.
Please pay attention to cooling airflow, which should have minimal obstructions especially from front side.
The print itself may be done by any type of plastic and requires minimum of support (4 pins contact soket and display hole areas only). All screw holes are extremely narrow, so please prepare it according to used fasteners.
Have fun and do not forget to share remixes.