Eiffel Tower - 50 cm - 7 Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modular Eiffel Tower (50 cm) – highly detailed FDM model in 7 parts, nearly support-free.
- Ocena
- 5 / 5
- Polubienia
- 31
- Wydruki
- 3
- Wyświetlenia
- 882
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Architecture & Urbanism
- Licencja
- Standard Digital File License
The 3D model of the Eiffel Tower consists of 7 segments that are stacked on top of each other and permanently joined using a bit of glue. The total height is 50 cm.
To print the model, a build volume of at least 210 × 210 × 130 mm is required, making it compatible with most common FDM printers.
This Eiffel Tower model is currently the most detailed FDM-printable version I’m aware of.
Since no official blueprints of the Eiffel Tower are publicly available, I created the model over the course of three weeks of manual work, based on dozens of detailed photographs. Many architectural features were carefully recreated to stay as true to the original as possible.
The complex structure of the Eiffel Tower posed unique challenges for FDM printing. Each segment was specifically optimized to reduce the risk of failed prints to nearly zero.
Moreover, the model requires no support – only Part 1 needs (simple) support structures in order to avoid splitting the segment further.
The segments were designed and thoroughly tested for printing with PLA, a 0.4 mm nozzle, and 0.2 mm layer height.
Scaling the model is not recommended – especially enlarging it is likely to result in failed prints due to disproportionately increased delicate structures and bridges.
For those who want to go even higher:
I’ve also published a separate XXL version with a tower height of one meter of this Eiffel Tower here on Printables.
Printing information
All STL files are correctly aligned.
Layer height: 0.20mm STRUCTURAL
Perimeter: 2
Additionally, I recommend turning on “Extra perimeters on overhangs” (Expert mode required). It’s under “Print Settings → Layers and perimeters” in PrusaSlicer.
Helps a ton with tricky overhangs!
Infill: 10 % - I use gyroid for a nice balance between structural stability and print speed.
Support: The model is designed to print without support, except for Part 1, which requires support structures to ensure clean results due to overhangs.
The necessary slicer settings for this Part 1 are clearly illustrated in the image below.
Assembly Instructions
Each part should be joined using a small amount of superglue. Before gluing, always check that the parts fit together as intended.
I recommend assembling the tower from bottom to top.
I am looking forward to your Makes! :-)
If you like this design, feel free to check out my others here.