Tippmann Stormer Elite Handguard and Magwell

This is still somewhat of a Prototype, i can't guarantee it to work and am currently working on a slight cracking issue near the bottom handguard screw. (if u want to Remix it, or can easily fix issues you might find i can send .OBJ files to you)

Print the Handguard standing on the front part for maximum strength,

I used ABS, 35% infill 3 walls

the screws are all Tippmann Screws that came with the Marker except for the one securing the Handguard retention Picatinny adapter

You need the Magwell screws as well as screws from the adapter for Hopper use only adapter: 

All Magwell Screws

Hopper only adapter: Back screw as wall as Picatinny rail screw

Screws1-3: Magwell screws and long Hopper only Adapter screw 

Screw 4: Picatinny rail Screw from  Hopper only Adapter 

Screw 5: Random m4 screw

you also need a spring for the mag release about 6.5mm diameter

You also need to remove one of the chassis screws for the bottom of the handguard to screw into, so you either have to print the Magwell, too or cut down the original one

use a bit of filament as pins for the Mag release, glue it into the hole on the mag catch, then insert it, put the spring in and then secure the mag release button by adding a little glue and then melt the filament standing out and press it onto the button as shown in picture