Core One squash ball feet remake tall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made the Squash Ball feet 75 mm tall between flat nest and bottom. To enable putting Gen2 drawers under the Core One.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 34
- Wydruki
- 1
- Wyświetlenia
- 349
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to add Gen2 drawers to the core one. I like the squash ball feet, but they were too short. I made the taller version.
Normally one screw holds the foot in the Core One. That is OK for the shorter version. With the longer version that may put too much stress on a single screw when moving the core one. I drilled and tapped out the bottom ledge of the Core one in 4 places, for the second screw in the foot. If you tighten the first screw, the foot can be used for a drill guide. I still had the shorter foot and used that as a drill guide. If you don't have a tap, a thru hole can be used with a nut on the other side. It takes some work to get the nut on, but it works. Drilling into the bottom ledge of the Core one only, not into any interior areas. Make sure not to drill any wires related to the LCD.
3mm x 12 and up to 16mm long screws work. There is a lot of room for the end of the screw to stick through.
The squash ball fits the feet, but the squash ball may be a little tight in this version.