1 / 9
LILYGO T-Deck Reset button disabler
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The LILYGO T-Deck Reset button to prevent accidental resets
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 516
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (15)Powiązane
The LILYGO T-Deck Reset button is very prominent and easy to accidentally initiate resets.
This is a replacement button to completely disable or at least make it very hard to initiate a reset.
Two versions of the model are attached:
- Flush Button
- This one should sit fairly flush with the surface. Although I designed it not to be able to reset, I did notice with enough pressure it did cause reset.
- Recessed Button
- This one sits below the surface. If you do manage to reset it, it will definitely be an action taken with purpose.
Print Profile:
- PETG 0.10mm Detail profile with a 0.4 nozzle.
- Infill: 30% infill, but I'm not sure it matters.
- Supports:
- Support under the flex tab
- Remove supports from the main button
- Believe me, it's a pain to clean out if you do print supports.
Post-processing:
- Just needs an X-ACTO to pick at the supports and slice past any brim. It could be easier or harder depending on your filament and print settings.
Assembly:
- Just a note, that the T-Deck Pro comes apart with multiple layers of pieces connected and on short leashes. Best just to crack it open just enough to slide out the old button and slip in the new one. It's not that bad, but it's a bit daunting to look at when first pulling it all out.