K1 Max rear fan hole blocker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blocks the rear fan hole in the K1 Max, ensuring your warm enclosure stays that way.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you want to print enclosed with the K1 Max (or any printer), you want to retain as much of the warm air as possible. The rear exhaust fan is completely open to the outside world, however, which will lose you a lot of heat even if the fan isn't running.
This mod closes that hole. No hardware is required: it just slides in. The fit might be a bit tight at first: persevere and it'll fit. Removing it is easier, in case you want access to the fan, or to print un-enclosed and get more air moving. You don't need to remove the fan to install this mod.
Do not use PLA for this: it suffers from creep, doesn't like the heat, and is quite brittle, which could cause it to break when you install this mod. PETG is an OK choice, ABS (or ASA) is probably the best. Avoid composites (aka, CF or GF filaments) for this mod, as this makes the part much more brittle.
This part is designed to print with a 0.2mm layer height, but will probably work for larger layer heights too.
I've included both the FreeCAD source, and a STEP file. This should allow you to both print the file (all Slic3r descendants can read STEP files, including PrusaSlicer, OrcaSlicer and Bambu Slicer), and modify it to suit you as well.