Rockwell BladeRunner Replacement Parts and Accessories - Knob, Blade Grip, Vacuum Attachment

Another thrift store find that did not have all parts. The 6mm knob is used on several parts of the machine. It requires a 6mm nut to be glued in. The vacuum attachment was missing. I created one that fits with the approximate size 32mm or 1-¼" vacuum hose. The attachment locking tabs are small enough that it does not need supports. The blade grip was not missing but I created one just in case I lost the original. The blade grip does print with the 45 angle down. This allows it to be printed without supports. All three parts were printed with PLA at 0.20 layers, 3 walls, 25% infill.

Miter Stop: I made a positive stop for the miter for repeated stop cuts. Since there are only certain places in the track for the t-nut, the slide will reach to the next place. Needs one 5mm hex bolt and nut. Prints without supports but t-nut will need the hex hole cleaned out. Printed with PLA at 0.20 layers, 3 walls, 25% infill.

Power Cord Wrap: Five pieces, the block matches the flat and angle of the saw base. A 6mm hex bolt goes into the block, through the saw base with the bushing into the hole on the bottom side. This allows a nut to be used since the hole is too small for a socket. The bar and uprights use a 4mm screw. I used hex style for the uprights for layer line strength. The clip is a tight fit for clipping the cord end to itself. No supports needed. Printed with PLA at 0.20 layers, 3 walls, 25% infill or better.

I have seen a Worx version of this that looks identical so all parts should work for it also.