Team Associated Pro4 SC10 shorty battery tab mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These pieces let you hold a shorty LiPo battery pack with carbon fiber tabs for quick and easy battery changes.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These simple pieces allow you to use carbon fiber battery hold-down ‘tabs’ in the Team Associated Pro4 SC10 for ‘shorty’ style batteries, like these tabs for the TLR 22x4 4WD buggy:
The pieces have a single hole each for a countersunk flat head M3 screw (30mm long needed for the 4800mAh Protek, 35mm long needed for the 5000mAh Protek). The taller style is shown here:
Then a nyloc nut and washer for each is all that is needed to hold the tabs.
Installation does require drilling two holes in the chassis, but the pieces themselves can be used as drill guides for a 3mm drill bit. Slide each piece up against the battery strap slots in the chassis, and the holes willl be perfectly located. Then a countersink bit should be used on the bottom to let the M3 screws stay slightly recessed from the bottom surface of the chassis:
I printed mine from 3D Fuel black PCTG, but most likely PETG could work fine as well. They can print in pairs directly on the build plate as shown with no supports needed.
The “SC10 battery tab mount v0” is the shorter one (~20mm) for the 4800mAh Protek battery, and the “SC10 battery tab mount v2 tall” is taller (25mm) for the 5000mAh Protek. Enjoy!