Printable Galaxy Tab S-Pen Tip

Warning! This is not a .stl or a .3mf, this is a custom crafted .gcode file.

This is a replacement tip for the Samsung Galaxy Tab S-Pen. It is remixed from fullcontrol.xyz “Pin Support Challenge”, and the .gcode should be generic enough to be portable across printers. Replacement tips are hard to find online and even then, they are expensive around .9 USD each in my area. This 3d printable replacement tip prints in 3 minutes and uses only 21 millimeters of filament, total, basically free.

Specifications:

• 210°C Nozzle Temp
• 50°C Bed Temp

Requirements:

• Any PLA is fine as long as it is dry
• Calibrated extrusion multiplier
• Flush cutter
• Pliers to pull out the original tip

Step 1: Print the .gcode file, the printer will home, purge a small amount, and print a base circle to hold to the plate, as seen in the photo. It will then do a tower with a calibrated amount of plastic, that is the actual tip.

Step 2: Remove the model from the bed and cut out the bottom part of the tip with a flush cutter, it is not needed. You can remove any stringing at the very top of the tip.

Step 3: Try out the tip. Remove the original tip with the pliers, don't apply too much force or it will deform. First, the printed tip should glide in easily but securely fit in the last ~5 milimeters. If it does not fit, or it is too loose all the way in, try reprinting it with +-5% flow percentage. 

If you print one, please post a make. I used plain PLA and it works well, it does not scratch the surface. And if it gets damaged, I can print another. I used it on my Samsung Galaxy Tab S9+ S-Pen, I don't know if it will work on Galaxy Note S-Pens.