1 / 4
FreeCAD Slim CR80 (85.6×54 mm) Badge Holder (Minimal, Supportless) — zdjęcie 1
1 / 4

FreeCAD Slim CR80 (85.6×54 mm) Badge Holder (Minimal, Supportless)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ultra-slim, support-free holder for one CR80 NFC/ID card; snap-fit with lanyard/clip points.

Ocena
5 / 5
Polubienia
10
Pobrania
84
Wydruki
2
Wyświetlenia
500
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Public Domain

A small, low-profile, one-card holder designed around the CR80/ID-1 standard (85.6 × 54 × 1 mm). It uses a small internal stops to keep the card secure. A lanyard/clip slot lets you wear it vertically without extra hardware.

Highlights

  • Holds one CR80 NFC/ID card (bank/ID/MIFARE/Desfire format);
  • OpenSCAD design for easy remixing;
  • No supports required – no post-processing needed;
  • Fast print - just 12 minutes for standard settings;
  • One-piece print - no assembly required;
  • Slim design - only 3 mm thick;
  • Minimal size - 95.8 x 56.5 mm;
  • Minimal material use - 2.07 g PETG or 0.68 m x 1.75 mm of filament;
  • Three mounting holes – two Ø4.6 mm and one 4.6 × 19.6 mm slot.
     

Dimensions & Fit

  • Card standard: CR80 / ISO ID-1 – 86 × 54.5 × 1 mm;
  • Outer holder size: 95.8 × 56.5 × 3 mm;
  • Internal clearance: Tuned for standard FDM printer tolerances.

Note: Not designed for thick card sleeves (more than 1 mm) or stacked cards (more than one);

Note: No scratch protection.

Note: No RFID/NFC shielding.


Printing Recommendations

  • Orientation: Print flat on the back face (opening facing up);
  • Layer height: 0.2 mm (0.16–0.28 mm works);
  • Perimeters/Walls: 2–3;
  • Top/Bottom: 2–3 layers;
  • Infill: None;
  • Supports: None;
  • Brim: None;
  • Elephant-foot compensation: 0.2 mm recommended for crisp openings.

Materials:
 

  • PETG or ASA/ABS: strong and durable – ideal for badge reels;
  • PLA/PLA+: Prints well, but avoid prolonged heat exposure (e.g., hot car);
  • Works on both smooth and textured build plates (textured gives a nice finish).
     

To open the model CAD file use FreeCAD.

Tagi