1 / 1
Freewing Avanti S 80mm v1 and v2 Nose Gear Brace — zdjęcie 1

Freewing Avanti S 80mm v1 and v2 Nose Gear Brace

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nose Gear Brace to absorb impacts on the nosegear mechanism during bumpy landings.

Ocena
0 / 5
Polubienia
3
Pobrania
43
Wydruki
1
Wyświetlenia
224
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Nose Gear Brace for the Freewing Avanti S 80mm v1 and v2 (no difference).

Don't spill epoxy on the gear mechanism !

Put a wad of kitchen paper or something similar underneath. 

Then sand the piece on the sides, apply some epoxy on the inside of the hull where the piece will sit and also on the brace's outside sides. Then insert the piece from the back and let the gear come down so the gear rod presses tightly against the hull while the epoxy sets, that way you'll get a perfect fit.

Print in whatever filament you like but keep 3 walls and 3 top and bottom layers, and a 25 percent gyroid infill.