1 / 8
Orbiter NiteHawk 36 12V Fan Adapter for Ratrig ToolHead — zdjęcie 1
1 / 8

Orbiter NiteHawk 36 12V Fan Adapter for Ratrig ToolHead

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The only thing the Nitehawk is missing is 12V to drive a good 4028 fan.

Ocena
0 / 5
Polubienia
2
Pobrania
18
Wydruki
0
Wyświetlenia
321
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Until the O2S comes out, I'm not aware of a toolboard that runs USB, gives you another USB for Beacon, and 12v to run a decent 4028. It seems like there was one more feature I needed, but I can't think of it now.

After trying a few expensive and laggy 24v 4028's, I set off to put 12V on my toolhead, to put my old fan back on. I've found there are a few people who have had the same issue, I just got this working on mine, of course, right in time for the O2S toolhead release… that's my luck.

This mount uses both sets of screws for more rigid mounting, and there's a pocket behind the Nitehawk to glue in a 24-12V Buck Converter. Your 24v fan output goes around and behind, and to the buck, then out to the added JST port. Your fan plugs into the new port on the side of the mount.

This is the buck converter I used:       Amazon.com: eBoot 6 Pack Mini MP1584EN DC-DC Buck Converter Adjustable Power Supply Module 24V to 12V 9V 5V 3V : Electronics      I glued the buck converter into the pocket, and covered it with Kapton tape, I forgot to take a picture at that point, i'll see if I can get one later. 

I just got this whole thing back up and running, so i'll include updates as they come.