Carvera Air Magsafe mount for filming

⚠Disclaimer⚠

Use this model on your own risk. I will not be responsible if you damage your CNC or Mobile device using this model.

Putting a $1000+ Iphone near a bit rotating at 10000 revolution per second is maybe not the best idea ! I'm dumb, this does not mean you have to be.

Also some details are missing and instalation process is not the clearest for now, I will update the model later with exact information (screw sizes) and photos for instalation process

Introduction

This is a model that allow you to place your Magsafe compatible device at an angle to film your milling operation on your carvera Air

This model is compatible with air assist but is not with the vaccum shoe.

Needed parts

1 M4 screw (I don't remember the size, medium like 8mm to 14mm long)

2 M3 screw (I don't remember the size, small like 4mm long)

1 Magsafe magnet ring: https://a.aliexpress.com/_ExWnpEa

Instalation

1. Remove the stock vacuum hose holder
2. Remove the probe holder
3. Install Magsafe magnet ring
4. Place the holder by first placing the probe screw riser inside the hole then rotate it on the vacuum hose holder screw riser
5. Screw the holder with 1 M4 screw on the vacuum hose holder and 2 m3 screw on the probe screw

Usage

• Don't close the Carvera Air lid, as depending on your operation you device may hit the lid and fall of on the working area and cause damage
• You will not be able to use the vacuum shoe provided by maker, I'm working on a compatible vacuum shoe that I'll share later. To clear up debries and have good shots use the air assist.
• The example shot provided are taken with a Iphone 14 pro on wide angle view.

Example

Most of the shots from those two shorts have been made using this magsafe holder: