1 / 4
Ikea Antilop baby chair step — zdjęcie 1
1 / 4

Ikea Antilop baby chair step

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It's an adjustable step for the Antilop baby chair you can buy in Ikea

Ocena
0 / 5
Polubienia
11
Pobrania
41
Wydruki
0
Wyświetlenia
249
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

So another quick one. We read somewhere or someone told us that it's better that a baby chair has a step so that the babies legs are not dangling in the air. We had this old Ikea chair we inherited and it came with no step. So I made a model. It seems to have worked out fine, the model itself has one mountable leg and the middle piece. Just copy and paste and cut to get the three pieces. Place it on the build plate with the step surfaces towards the build plate, does not need any supports. I am not sure if the middle piece is needed, but I wanted it and I made it, it's made so that you can adjust the height of the steps as the child grows (also not sure if needed). The angle of the steps is not a 100% perfect, I measured that about 10 degree slope should work and it sort of does. Maybe in actuality it needs to be 11 degrees but oh well, fits well enough to put together. In order to slide the steps on take the metal legs out and go from the top. I used M5 screws to put it all together with respective washers and nuts. The screws on the steps should be 20mm, the ones in the middle can be 16mm. I printed it in PETG with 3 perimeters and 15% Adaptive cubic infill at 0.2 layer height. Seems to be sturdy enough to survive, but your mileage may vary. 

Tagi