AirTag Case for Rockrider ST Bike Stem (EUFY AND UGREEN)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case will hide your Eufy or UGREEN smart tracker under the stem of a Rockrider or similar bike.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 506
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Smart Tracker Case for Bicycle Stem
I designed this Smart Tracker Case because I wasn't satisfied with the existing options available online (hiding under the seat, top tube mounts, etc.). Those solutions are either too obvious or interfere with proper signal transmission. This design allows the AirTag to maintain optimal connectivity with distant devices while hiding in plain sight, perfectly integrated into the stem profile.
Important Compatibility Note:
I strongly recommend purchasing this specific stem model, as shorter lengths will not accommodate the AirTag's width properly:
Decathlon BTT Stem 1 1/8" Ahead 31.8mm
Order the 90mm length option.
Tracker Compatibility:
I used the UGREEN AirTag for my bike but I deisgned both Eufy and UGREEN, the UGREEN it's currently cheaper and features a narrower profile (36mm vs 37mm). This 1mm difference is crucial as it allows the case to perfectly mimic the stem's width for seamless integration.
Available Files:
Both UGREEN and Eufy compatible models are included in this upload. Additionally, the complete CAD files are available on OnShape if you need to adapt the design for different stem models. I specifically chose this Decathlon stem because of its predominantly flat surface, which provides optimal mounting conditions.
Assembly Instructions:
The case consists of two parts: an upper and a lower section. Place the AirTag inside the cavity and apply cyanoacrylate adhesive to the alignment holes. While the case is designed to stay securely in place without adhesive, using glue will provide additional protection against water infiltration and vibrations that could affect the AirTag's performance.
You can also change the default separators or buy new ones if you are migrating from another kind of stem
Print Settings
Supports:
Supports needed
Resolution:
0.2 layer height
0.4 nozzle
Infill:
10 ~ 15%
Perimeters:
3 or 4 recommended
Filament: PLA or ASA