Positron Bed Connector Support Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small clip that should help support the bed at the connector.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is to add some additional support to the bed. Designed for v3.2 batch 2 with a glass bed.
The clip is designed to fit around the connector. It works by applying upward force from the bed while also applying some down force against the bottom of machined bed carriage block. I've added holes to press fit 6x 3mm magnets. The magnets are not required and apply no force, but I found it helps keep the clip in place when the bed is not connected. And the magnets are useful to mount the clip on the x-axis rail when folded for storage.
The tolerances are tight and I find it helpful to press up on the clip as you press the glass bed into the connector. You shouldn't have to press too hard. If you do, you may need some sandpaper.
Recommend printing in ABS or ASA and using the following print settings(Voron's Recommendations):
Layer height: 0.2mm
Extrusion width: 0.4mm
Infill percentage: 40%
Infill type: grid, gyroid, honeycomb, triangle, or cubic
Wall count: 4
Solid top/bottom layers: 5
Supports: NONE