OpenAstroTracker Controller Enclosure

This is an enclosure to house all of the required electronics modules for the OpenAstroTracker controller.

https://wiki.openastrotech.com

It has standoffs and cut outs for the following:

1 x MKS Gen L v2.1 Controller Board with 5 x TMC2209 stepper drivers

https://github.com/makerbase-mks/MKS-GEN_L

1 x Neo6mv2 GPS module plus antenna

https://components101.com/modules/neo-6mv2-gps-module

1 x Arduino 16 x 2 LCD & Key shield

https://www.jaycar.co.uk/arduino-compatible-2-x-16-lcd-controller-module/p/XC4454?utm_campaign=redirect&utm_source=XC4454r&utm_medium=web

5 x GX12 4 pin locking connectors, for the stepper outputs

1 x Power Jack

https://www.amazon.co.uk/gp/product/B07QPZTHDK/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1

1 x Sliding Switch (for putting the MKS into firmware upload ‘mode’ - see the OAT wiki.

https://www.amazon.co.uk/gp/product/B00BQLAIW2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

All of the standoffs accept M3 brass inserts - use shorter (6-8mm) M3 screws on the MKS board and the GPS module. Everything else can use upto 12mm M3 screws

Print each half to the case with the largest flat side down, and you will not need any support material.

I printed mine in grey Prusament PETG.