Universal Cylindrical Basket (univerzální kulatý košík), no supports, parametric, any size!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print a cross-slat cylindrical basked just to your desired dimensions. Make whatever size you need.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This fully parametric 3D model lets you generate a printable cylindrical basket built from a cross-slat lattice structure. Diameter, height, slat thickness, and spacing are independently adjustable. Designed to print in one piece without support, bottom-down. Ideal for organisation, gifting, or decor. A rectangular sibling is also available.
The main file that should interest you is the SCAD source – see below for more detail. Some sizes are also pre-calculated, with hints for possible use:
| Diameter × Height (mm) | Title | Description |
|---|---|---|
| 77 × 158 | 0.5 L Can Holder | Sized to hold a standard 0.5 L beverage can (inner space ~67 × 148 mm). Can be used as a tall pen cup, kitchen utensil holder, or single-can cooler sleeve. |
| 77 × 128 | 0.33 L Can Holder | Fits a 0.33 L beverage can (inner space ~67 × 118 mm). Works as a can holder, compact flower vase sleeve, or toothbrush cup. |
| 90 × 60 | Desktop Cup | A short, wide basket (inner ~80 × 50 mm) ideal for holding paper clips, erasers, push pins, or wrapped candies. |
| 110 × 100 | Small Utensil Holder | A practical size (inner ~100 × 90 mm) for holding kitchen utensils, markers, or craft tools on a countertop. |
| 130 × 140 | Snack Cup | Medium basket (inner ~120 × 130 mm) for storing wrapped snacks, tea packets, or cosmetics. |
| 150 × 180 | Plant Pot Cover | Sized for a small potted plant (inner ~140 × 170 mm), providing a decorative cross-slat look while allowing airflow. |
| 180 × 120 | Bathroom Caddy | Larger format (inner ~170 × 110 mm) for rolled hand towels, bottles, or bath accessories. |
Parametric Print
To make a custom size use the Universal-basket-round.scad file. The top two lines of code set the dimensions: dia, high. Just modify the numbers you see. They are in millimetres. The setting correspond with the outer dimensions of the basket. The wall bars have a 5-mm cross-section so you need to add 10 mm to each if you start with inner dimensions and you'll be fine.
For fine-tuning you can also modify the width, thickness and spacing of the slats, as well as that of the corner bars, and the stagger of the slats.
Please note that my current algorithm for modelling the helix is somewhat inefficient. On my laptop the largest example takes 20 minutes to render. The smallest one takes three.
I print the baskets in PLA, 15-% infill, 0.2-mm layers.