Heat Insert Press from Mk4s to CORE One conversion leftovers

After converting the Mk4s to the CORE One I had a lot of leftover parts, so I made this heat insert press out of them.  Feel free to remix this model.

Parts reused:

• Old print bed
• 2 x 8mm rods (from the X-Axis)
• 4 x 8mm bearings (3 from the X-Axis, one leftover from the bed)
• 4 x Rubber feet
• 2 x idler pully pins
• 29 x M3x10 screws
• 8 x M3 nuts
• 2 x M3x12
• 5 x M3x6
• 4 x M3 washers

Things you need to get (Linked is what I got):

• Soldering Iron (https://amzn.eu/d/bNrLjni)
• Heat Inserts M3 x 5 x 4 (https://amzn.eu/d/4hSooH7)
• Retractable Keychain (https://amzn.eu/d/93SfgPU)

Print Settings:

• Material: PETG/ABS/ASA
• 0.2mm layers
• 4 Walls
• 5 top and bottom layers
• 40% Infill
• Orientation of the parts should be correct

You will need supports on these surfaces of the "Rod holder bottom" and "Carriage front". Other parts should not require any support:

If you print the bed with ASA or ABS I recommend scaling the X-Axis up to 100.7% to compensate for heat shrinkage:

Installing the heat inserts:

• Rod holder bottom:

• Carriage front:

• Adapter:

• Rod holder top:

Installation: (use the images as reference)

1. Mount the “Rod holder bottom” to the old print bed and secure it with 5 M3x10 screws (Don't over tighten the one in the back).
2. Slide the Rods in from the top until they are flush with the bottom of the bed (they stick out of the “Rod holder bottom” a bit) and secure them with 6 M3x10 bolts and 6 M3 nuts.
3. Add the printed “Bed” and secure it with 4 M3x10 screws.
4. Screw in the 4 “Foot” using 4 M3x10 screws. DO THIS BEFORE YOU ADD THE RUBBER!
5. Slide and press in the 4 rubber feet.
6. Put the linear bearings on the rods (2 each) and secure them in the “Carriage front” (flat part is down) with the “Carriage back” and 4 M3x10 screws (Check that carriage slides freely).
7. Press the “Rod holder top” on the rods with the heat inserts facing backwards. Check at the indication slots that the rods are all the way in.
8. Add the “Keychain holder carriage” (2 heat inserts on top of the carriage) and the “Keychain holder bottom” (2 heat inserts on the back, make sure the lip faces down) with 4 M3x6 screws.
9. Take the 2 idler pins and put the rolls on them and add a M3 washer on each side (you can add a but of grease as well) and slot them into “Rod holder top”.
10. Add the retractable keychain.
11. Mount the “Adapter” with 4 M3x10 screws.
12. Add your soldering iron with the “Clamp” using 2 M3x10 screws.
13. Add the “Endstop” to your needs using 2 M3x12 screws and 2 M3 nuts.
14. Use the cable “Clamp" to secure the cable at the top either left or right.

For Remix: