Pincushion for Mercury 2 Plus turntable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A turntable for the Mercury 2 Plus that includes multiple 1.5mm holes for insertion of wires as custom model supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a "pincushion" for the Mercury wash/cure station. I did it to address the times when I wanted to position a model on the turntable in some other orientation than laying flat.
I had a number of mild steel wires (probably florist wire?) with a 1mm diameter. I made a plate to mimic the turntable stage. It has 3mm cap head screws on the bottom to engage the curing station drive holes & a couple of washers glued into depressions (26x2.8mm) for the magnets to grab. The top side has an array of 1.5mm holes. I can place wires in the holes & bend to get the type of support I want for those times when flat just won't do as well as something else.