1 / 3
Zyxel GS1200-5HPv2 10 inch 1U rack mount — zdjęcie 1
1 / 3

Zyxel GS1200-5HPv2 10 inch 1U rack mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple 1U 10 inch rack mount for Zyxel GS1200-5HPv2 network switch

Ocena
5 / 5
Polubienia
3
Pobrania
59
Wydruki
1
Wyświetlenia
334
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a mount for the Zyxel GS1200-5HPv2 network switch so it can be mounted in a 10 inch rack.

The mount is 1U high, and the switch mounts flush with the front. The total depth when mounted in the rack is no more than then depth of the switch, which is 84 mm. The shelf sits 1 mm below the opening in the front, so that the rubber feets can be left on the switch. The shelf is kept minimal to save plastic and to save space in the rack, so something can be mounted in the back of the rack behind the switch too.

The switch is fastened to the mount using four 6 mm long M3 screws. They will be screwed into the press nuts in the bottom of the switch chassis that holds the PCB inside the switch. The maximum usable depth in the nuts is ~2.5 mm, so longer screws than 6 mm cannot be used. I chose this way instead of using the wall mount holes, since this way is easier to fasten securly. The hole for the switch in the front is also fairly precise. So depending on your printers precision you may need to do some post-processing.

The mount has been designed to be printed with the front down towards the printbed. Printed this way, no supports are needed.

Tagi