1 / 5
Del Sol/ Civic EG Rear Lower Control Arm Bushings — zdjęcie 1
1 / 5

Del Sol/ Civic EG Rear Lower Control Arm Bushings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Del Sol/ Civic EG Rear Lower Control Arm Bushings

Ocena
0 / 5
Polubienia
9
Pobrania
28
Wydruki
0
Wyświetlenia
213
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

These are bushings for the rear lower control arm for the 92-95 Honda civic and 92-97 Del Sol. These are for TPU only as they need to be flexible.

INSTALLATION:

To use them you need to remove the rubber from your old control arms and keep the inner metal tubes that the bolts went through that were inside the rubber so you can reuse them in these bushings. (FYI, the most common methods to remove the old rubber is either burn them out with a torch, or you can either press them out or cut them out with a hole saw, then finish cleaning them up with a wire wheel on a Dremel/drill and finish cleaning off the rubber from the metal sleeves with wire wheel on a bench grinder if you have one). You will also need to grind the outer lip of the metal sleeves that have that bump on the outside (see pic), it will be very difficult to install the metal sleeve in the bushing without doing that.

Also, in the holes where the rubber was on your old control arms is a very thin metal sleeve on the *outside* of the rubber that will be left in place in the control arm after you remove the rubber, this is ok and you do not have to remove these, I modeled the bushings to fit inside them because they were pressed in from the factory and are very hard to remove, just clean them up so they are smooth and have no rubber residue left on them.

Remember to grease bolt sleeves/tubes before inserting into bushings*

PRINT SETTINGS:

TPU ONLY, hard filament won't work or be safe

.24 layer height for good layer adhesion

7 Wall loops so the inner bushing is solid

30% infill

Print very slow, like 30mms this also helps layer adhesion

No support required

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ