Printrbot simple metal adapter for an einsy rambo board.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
after printing you will need 4x m3 nuts that you will install on the bottom of the plate. you will need 4 m3 x 10mm…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
after printing you will need 4x m3 nuts that you will install on the bottom of the plate. you will need 4 m3 x 10mm bolts for attaching the plate to the to the bottom of the printrbot, i designed them to be counter sunk to prevent shorting with the new board. and last 4 m3 x 15mm bolts to attatch the einsy rambo board to the plate. when done all the wires will sit flush with the bottom of the printrbot and the usb cable will be ran out the bottom through the wire routing slot, this will prevent you from accidentally damaging your usb port or if you go lcd then you won't use your usb port. watch your wires and triple check polarity of pinta probe and steppers before powering up.
I've added the marlin code that got the whole thing working, you may need to change your build volume and steps count as i have .9 degree steppers, 8mm 4 start lead screw and teh super z upgrade.
added lcd mount that i remixed from the prusa mk3, and fan mounts for the 50mm blower and 40mm fan i used noctura for the hot end.
update added marlin 2.0 firmware setup files. added sensorless homeing no need to plug in your end stops except the z probe
Print Settings
Printer Brand:
Printrbot
Printer:
Printrbot Simple Metal
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30
Notes:
I did abs but pla should be fine, this should also help isolate your board from the heated bed.
Category: 3D Printer Parts