1 / 1
VzBot 235 AWD CNC mounts for 2040 extrusion uprights. — zdjęcie 1

VzBot 235 AWD CNC mounts for 2040 extrusion uprights.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

VzBot 235 AWD CNC Plate and printed parts for 2040 extrusion uprights.

Ocena
0 / 5
Polubienia
16
Pobrania
75
Wydruki
1
Wyświetlenia
448
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

VzBot 235 AWD CNC mounts for 2040 extrusion uprights.

Files Included.

The full motor mount assembly with the printed parts installed, showing how the final installation should look. Both f3d and STEP format.

Printed Parts, STL's.

Also now included separately, are the CNC plate STEP files, Plate A 2040 VZ235 Alu V2 and Plate B 2040 VZ235 Alu V2. They can be directly used to upload to your CNC service.  Tapping of all the 2.5mm dia holes is required and can be done either by the CNC service or DIY by hand easily enough.

(Printed parts tested using Polymaker ASA, 40% infill 0.18 layer height)

The hardware is simple self source and is based off the Mellow VzBot 235 AWD Hardware kit. No BOM build list included at this time.

*Note: Check your motor shaft length as I have only added clearance on the underside of the plate for the rear top mounts for use of longer shaft motors. The front top plate has no additional clearance added, as for my use case it was not required. (4x LDO-42STH48-2504AC motors used)

*UPDATED 21/09/25  - Rear Mount Plate all extrusion mount holes now 4mm dia.                                              

PLEASE READ  - After rough cutting all separate parts from the CNC plate's, notice the joining tabs are all offset from each other, this is to allow the mirrored parts from each side to bolt back to back with each other to give a guide for a bearing if tidying up the cuts with a trim router. 

Credit to Simon Vez and the VzBot team for there amazing work and for providing the CAD file for the the printed VZ 235 that the measurements were taken from.