Delta T3 Fence End Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
End Clamp for Delta T3 Fence to prevent lifting of far end.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
End Clamp for Delta T3 Fence. This clamp prevents the far end of the fence from lifting off the table. This lifting can be an issue if you are using a fence mounted device such as a Little Proteus Powerfeeder.
Printing:
Any suitably stiff material should suffice. 20% infill, .25 layer height. The image shows the clamp printed in ASA, 20% grid infill, 4 perimiters or so… but PLA or PETG should be adequate.
Installation:
Remove the stock delrin bumper and sheetmetal hook. Using the original screws, mount my clamp.
Hardware:
Install a 5/16 nut into the slot in the lower section - or whatever nut will fit in a ½" x .3" space. Thread a bolt though the hole to clamp onto the bottom of the angle iron fence rail. It doesn't need to be super tight, but should take up any slack to prevent vertical movement.
See my other Delta T3 Fence parts! https://www.printables.com/model/1379620-tablesaw-delta-t3-fence-top-t-slot-t-track-rail
Post your makes and installs!