pi 5 official case with active cooler, small camera, display, sd card holder, nvme
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert for the official pi 5 case to include the active cooler, small camera, display, nvme drive, and sd cards.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
requires soldering and permanent modifications to lid.
products:
case → https://www.adafruit.com/product/5816
active cooler → https://www.adafruit.com/product/5815
nvme hat → https://geekworm.com/products/x1003
oled → https://www.sparkfun.com/sparkfun-micro-oled-breakout-qwiic-lcd-22495.html
nvme → https://www.adafruit.com/product/6089
camera → https://www.adafruit.com/product/3508
stemma cable → https://www.adafruit.com/product/4210
two standoffs (same height as active cooler) and four screws. i am using m2.5.
build:
pi 5 insert geekworm nvme needs to be glued together with super glue.
put the camera into the insert using the small camera insert and connect it to the pi.
insert the pi 5 into the case and use the screws to connect the standoffs. place the insert on top of the standoffs and screw it in.
you can cut the end of the stemma cable and solder it to the nvme hat. look up the pinout and be careful. once working and tested, you can cover with T-7000 glue to protect the solder joints. I used blinka to program the display.
in order for the lid to fit, the inner rim where the pins are needs to be snipped with a wire snipper. i cleaned it up with a razor blade. the pi sd card insert can be mounted here using the T-7000 glue, Make sure sd cards fit before you glue it in! You may need to modify this print in tinkercad.