1 / 3
Exact Replica of BEA30 Ventilation Grille Retaining Ring — zdjęcie 1
1 / 3

Exact Replica of BEA30 Ventilation Grille Retaining Ring

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A precise 3D printed replica of the retaining ring for the BEA30 mosquito screen ventilation grille, printed in PLA with

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
40
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This is an exact 3D-printed replica of the retaining ring used to hold the mosquito screen in place on a BEA30 ventilation grille. Designed from precise measurements, it fits perfectly as a replacement for the original part.

The ring has an outer diameter of 150 mm, a height of 4 mm, and a width of 4 mm. It includes two fixing holes with a diameter of 3 mm, positioned 1 mm from each edge of the ring.

By using this part, you can avoid the need to replace the entire VMC ventilation unit or wait for an official spare part to be shipped — saving both time and money.

This model has been tested and printed in PLA at 0.2 mm layer height, but you may use other filaments for increased durability if needed.

Easy to print with no supports required. Make sure to check the fit before final installation.

Tagi