Mini Bar clamp mod for Lantis Solostar Insulin pen

printed on a Flash Forge Adventurer 5m using Highspeed PLA, 100% infill and tree supports.

*only ran at 100% infill because it was going to use the same amount of pla @ 20% (since its so small I'm guessing) and wanted to print something at 100% at some point… likely wouldn't really be necessary, but ill leave that to the more experienced folks

call out to cmeier75_1265816 and BobCc_305011

their attached files helped me expedite this project after the better part of 3 weeks of trying to build some monstrosity from scratch. two nights ago, i located one of my mini bar clamps in the garage and was like…. oh gosh, this would likely be so much easier than trying to start from scratch.

after pulling the files down, i sliced the quick-grip-bar coupler up to use the already-in-place geometry so i didn't have to try recreating it from scratch, added a few shapes to better support the pen, then resized the pipe clamps and set it atop the assembly at a 90 degree angle. merged all the pieces into 1 large solid bit + the 2nd clamp part.

printing took about 42 minutes, 

assembly hardware is just two (2) m3 x 3/4" screws, 4 like sized washers and two m3 knurled nuts i had lying around, and the hex nut / bolt that came with the bar clamp for the replaced end.

if i redo the swappable attachment, i will make two notches in the clamp portion for the lid-latch on the actual pen (two itty bitty rectangular nubs on either side of the housing meant to secure the lid to the pen. 

also, having tested tonight, i will be looking for a properly facing bar clamp (current has the trigger arm facing away, will locate one w the trigger arm going in the correct direction), though mainly only to see what i prefer.