Meshtastic Faketec solar powered GPS car tracker node
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A magnetic attached solar powered Meshtastic tracker for your car.
- Ocena
- 0 / 5
- Polubienia
- 49
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 2637
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPFRONT!
I created a Discord channel for my Thermal vision builds but will add a #meshtastic channel there as well in case you have questions or problems. Please remain to the meshtastic channel for all sort of questions as all the other channels are ONLY for my thermal builds!
_________________________________________________________________________________________________________________________
Thank to Blackout concept for this amazing design!
Parts List:
FakeTec DIY Meshtastic Node:
gargomoma/fakeTec_pcb: A low-cost nrf52 device.
Self tapping screws: M3 x 8mm
https://de.aliexpress.com/item/1005008658505044.html
Magnets:
Lora Antenna:
IPEX to SMA: 2x 1.13IPXK-SMAK 8 CM
Solar Panel: Min of 2 pieces. Link leads to the 20pieces pack I got, but you can find smaller amounts as well or any other solar panel with the same measurement.
GPS antenna: HA-302
GPS Module: Single Module
2x M4x 25mm countersunk screw + spring washer+ nut
1x M4x10mm countrsunk screw +spring washer+nut
OPTIONAL:
Solar charger for more effective charging even in low light conditions.
Additional stuff you need: Wires, battery ( whatever you can fit) , epoxy to seal and fixate the inside of the antenna SMA outlets. silicone, Some sort of protective thin layer for the magnets so it doesn't scratch your cars paint.
Solar panel gets directly connected to the Pro micro s Battery + and - on a Faketec Rev.B board in case your not going to use the solar charger.