Atlas Craftsman 10f TH36 TH42 TH46 TH52 lathe Crossfeed gear
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Crossfeed gear replacement for 1937+ style atlas and craftsman lathes
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
My crossfeed gear key had been sheared off by the previous owner, and since everything is made of Zamak, there was no way to really repair it without silver brazing as solder would not stick and the original material melts at a very low temperature.
This crossfeed gear by the original designer was for Logan lathes, but has been resized to fit my atlas 10f TH42 lathe. I imagine it will fit all 10-inch atlas's and craftsman's of this vintage. It may fit the 6-inch and 12-inch models as well of this style. Drill a small hole for the retaining pin to fit through, otherwise it will deform the gear tube when tightened. Printed in PLA with 4 walls and 100% infill for strength. Print gear-side down and no supports are needed.