1 / 5
Magnetic Mounts for Rikon 10-326 Bandsaw Dust Chute — zdjęcie 1
1 / 5

Magnetic Mounts for Rikon 10-326 Bandsaw Dust Chute

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Added magnetic mounts and a shop vac adapter

Ocena
0 / 5
Polubienia
5
Pobrania
21
Wydruki
0
Wyświetlenia
184
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

The brackets have holes for 6-7 (in each hole) of these 12mm x 3mm magnets.  It will take about 48 or so magnets.  The two stacks on the side that are close to one another you will want to alter the polarity so they don't oppose one another.  This will become obvious when you try to install them and one is backwards.  I just put some tape over the magnets to keep them from falling out until I am ready to commit them.  

I printed it in PETG; 3 walls, 5 top & bottom and 15% infill.  I glued the original chute in place on the pipe and then dry fit everything and added a few drops of CA glue to hold it.  Then I flooded each brackets joint with thinner CA glue.  

The top bracket has a lip that rests on top of the lower door and keeps it from sliding down.  Goes on and off like a charm.  Here's a quick video of it going on.  Pay no attention to the small piece of shop debris stuck to the lower magnets. :)