2017 iMac Pro Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand to elevate an iMac Pro 2017 65mm and provide access under.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
My desk height left my iMac a bit lower than I liked, and I wanted to place it on my desk right where one of the cable access holes was located. This stand elevates the entire computer 65mm and allows it to be placed over a cable access hole, or to just use the extra area under it for storage.
Known to fit a 2017 iMac Pro 27".
I printed in black PLA. For the beams I used 20% infill in cubic (strong in all directions), and for the sides I used 10% infill in honeycomb (extra-strong in vertical compression). Make sure to use a deburring tool on the edges of the tabs that go into the sides so the bottom edge is very slightly chamfered. The parts fit extremely snugly on purpose, your printer needs to be dialed in.
I've included the Fusion 360 design file in case someone wants to remix for other size stands.