Vantage board game player mats (Stonemaier Games) Fits Bambu 256mm bed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Player mat for the board game Vantage. Prints in 2 pieces which slot together near seamlessly.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 228
- Wydruki
- 0
- Wyświetlenia
- 986
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted player mats for Vantage, to keep the cards from sliding about the table, and didn't want to pay $20 for the official addon mats, especially because I'll never need all 6 of them. Plus, it's so much more efficient economically to spend 8 hours designing, tweaking and printing your own! (Yes that is sarcasm, why do I do this to myself??)
I also have an X1C and a standard mat is too big to fit the print bed, so this is designed to be printed in 2 pieces, and the two slot together near seamlessly. The friction fit is decent, but I did not overengineer the fit because I intended to glue the two pieces together anyway. Fits nicely in the box as well.
Total height is 3.6mm tall, so they are also slightly thinner than the official dual-layer mats. The lip that keeps the cards from sliding is 1.6mm tall which is just tall enough if your cards aren't curved too much. I wanted to keep the profile as small as possible for box space considerations.
Latest addition is a small divot between the cards to ease getting your fingernail under a card, so they can be picked up without hacking up the edge trying to get under it.
Printed on an X1C at a .2mm layer height. No fancy settings needed.
