swancolorHD PCB Shell Cover with Ext Port

This is the STL data of the shell created for the swancolorHD PCB.

This variation has a hole on the right side for connecting expansion devices such as the WonderSwan's communication cable.
In the image, it looks like there is a slit in the center of the shell, but this is because the filament ran out halfway through and the rest was printed using different filament.
"top_cover_with_ext_port_plate.stl" is used to close the bottom of the extension port.
Please refer to the image for installation.

M2(OD3.5) insert nuts are required to make the shell.

The square hole on the back is for attaching a 6mm square tact switch.

By connecting it to the power switch line (POWER_S, POWER_D) of the WonderSwan Color, you can turn the power of the WonderSwan Color on and off after supplying USB power.

The four holes on the left side of the bottom cover are provided for mounting a 2x8cm universal board.
It can be used as a relay to connect a swancoloHD PCB to a WonderSwan Color PCB, or to add custom circuitry.

swancolorHD is an open source project for a consolizer created using the WonderSwan Color PCB published by zwenergy (https://x.com/zwenergy0).

You can use the main board data published in the "PCB" folder of the project linked below to create a PCB using a PCB order service such as JLCPCB.

For details, please refer to the link.

The Wiki linked to the custom project below contains information on the construction procedure, etc.

swancolorHD Project:
https://github.com/zwenergy/swancolorHD
GPL-3.0 license

swancolorHD Custom Project:
https://github.com/SourceK78/swancolorHD
GPL-3.0 license