1 / 3
PrusaWire Beta 1 - Y-Axis Idler High-Strength Remix — zdjęcie 1
1 / 3

PrusaWire Beta 1 - Y-Axis Idler High-Strength Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

NOTE: This is currently designed against the PrusaWire Beta 1 y-axis parts!  These are changing in the future which, if you upgrade to them, will make this part unnecessary.  Until then…

Overview

This remix dramatically improves the strength of the front y-axis idler on the PrusaWire - Beta 1 release.  Assembly is identical to the original with the exception of a M3 hex nut is used on the top (flush with the surface of the part) between the bushing and the printed part.  A M3 Nylock nut is used on the bottom to secure.  The resulting assembly is EXTREMELY durable.

Print Settings

  • I printed in Prusament Galaxy Black ASA, but any ABS or ASA would be sufficient.
  • Voron Print Specs
    • Layer height: 0.2mm
    • Extrusion width: 0.4mm, forced
    • Infill percentage: 40%
    • Infill type: gyroid
    • Wall count: 4
    • Solid top/bottom layers: 5
    • Supports: NONE

Printed Parts

  • y_idler_bracket_erikbuild-v20250816-1.stl
    • No supports are needed.

Hardware Required

  • Remix hardware:
    • 1x M3 Hex Nut
    • 1x M3 Nylock Nut
    • 1x M3x30 BHCS
  • Original Idler hardware:
    • 1x M3x6x0.5 shim
    • 2x F623-2RS flanged bearings
    • 1x M3x6x3 bushing

Assembly Instructions

  1. Print all models.
  2. Install M3 Hex nut in the top of the part.  You can use the screw (placed through the bottom hole) to draw in the hex nut until it is flush with the surface.  Remove the screw afterwards.
  3. Press the M3 Nylock nut into the bottom of the part (bottom of the nut facing up).
  4. Assemble the idler hardware: screw head → shim → flanged bearings → bushing
  5. Screw this assembly into the idler, through the hex nut, into the nylock nut.
  6. Done! :-)

Tagi