Sonoff 4CH Pro R2 enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An enclosure/case for a Sonoff 4CH Pro R2. Below the sonoff there is some room for wires or/and Screw Terminal Blocks.…
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 216
- Wydruki
- 2
- Wyświetlenia
- 1621
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An enclosure/case for a Sonoff 4CH Pro R2. Below the sonoff there is some room for wires or/and Screw Terminal Blocks. The walls are 3mm thick.
I have used m3 Brass insert nut Injection Molding from https://www.aliexpress.com/item/32961915881.html for closing the lit with m3 screw bolts.
For the cables going in I used 5 Cable Gland's PG9.
I have used this for controlling blinds using the schematic from https://lamiacasaelettrica.com/sonoff-tapparelle/
I printed the holes with support but I don't know if it is really needed. I used PLA.
Everything fits after printing on my printer. I did not adjust this for my printer.
So if it don't fit, don't blame me.
On my printer (P3Steel) printing the case (20% fill) takes about 10.5 hours and the lit about 2.5 hours.
Category: Electronics