Pedal Sensor Holder for Swytch e-bike Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to mount a Swytch pedal sensor to a 28.8mm frame.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This print can be used to connect a Swytch e-bike pedal sensor to a frame with a 28.8mm diameter bar near the pedals. You probably don't need this to mount the sensor to your bike, the included hardware on the pedal sensor is pretty adaptable and works with many bikes. However, if your bike is an odd one, or you've managed to dramatically disassemble the pedal sensor housing in an effort to get the cables to route juuuuust right, read on.
This fits on your bike near the magnetic ring that goes around your pedal, on the opposite side of the frame from the chain. The pedal sensor should be mounted with 3mm of distance to the magnetic disk, and this is very sensitive to distance increases, so spend some time tweaking this so that it's as close as possible, but doesn't contact the disk while you're riding. Like the rest of the Swytch system, this is held in place with cable ties.
It's probably a good idea to print in a strong, UV-resistant material like ASA. That said, the one I printed in plain PET is going strong after a couple of summer months, so \_(ツ)_/