Sodastream CO2 bottle stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Sodastream CO2 bottle stand with integrated lever to easily lock the stand to the bottle.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 116
- Wydruki
- 1
- Wyświetlenia
- 485
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A stand for a 60mm Sodastream CO2 bottle. The stand has an integrated design with a locking lever that locks the stand to the bottle and preventing it from sliding out if you move the CO2 bottle around a lot - like I do in my brewery.
Nice looking design and very functional! Suitable for anyone using a CO2 Sodastream bottle for anything else than in a sparkling water machine.
1 pcs needed for each file:
-The main body is printed as loaded in the slicer with 6 perimeters minimum - WITHOUT supports (PLA)
-The lever is printed as loaded in the slicer (on it's side), with as many perimeters (somewhere above 15) needed to make it a solid piece - WITH supports (PLA)
Once you have the main body and the lever printed. Carefully remove the supports from the lever with a suitable pair of pliers, and if needed (an exacto knife or similar).
Squeeze the tip of the lever completely together and gently insert it into the main body so that it slides into position over the corresponding knobs. By flipping the lever down (as in the picture) you lock the stand to the bottle, and by flipping it up you release it.
Easy peasy…I hope you enjoy the simple but yet very functional design