Xpeng G9 (model 2023) Phone cooler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use the cool air from the vent to cool your phone while charging
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
When wirelessly charging your phone in the XPeng G9 it can get pretty hot. In order to prevent this the new 2024+ models will cool the phone using special air vent at the back of the charge pad.
For older models (2023) the heating is still an issue. This 3d model will redirect the airflow from the middle vents towards your phone.
It works best if you set the direction of the air flow upwards through the AC menu. This was the vent in the middle console is mostly used.
It is advised to use filament that withstands higher temperatures, especially if you live in a hotter climate. PLA does not withstand the high temperature that can be present in a car on sunny days.
PETG is better suited.
Supports are needed. I used Tree supports, build plate only, with the model rotated on its side.