"Vanilla", a pseudo-default T114 Enclosure.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easily-editable, "KISS" FOSS Enclosure for the T114. Do with it as you will.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- GNU General Public License v3.0
Forword: I am really bad at 3D modeling. That spaghetti-tree of garbage you're about to witness if you're good at FreeCAD? It works. That's all I can say. I did a lot of redundant things I'll get better at later.
The main goal of this project was to create a case that anybody could grab, throw into blender and stretch to fit ANY battery…. and I did just that. Want it wider? Move the hole and the left side. Want it longer? Stretch the bottom. Want it thicker? Extrude the box wider and pad the back of the chip. Want to ditch the antenna and throw one in the case? Delete the hole!
(The Default) Materials:
Battery: Makerfocus 2000mah
Chip: It's a T114, but ok
Antenna: Whatever fits that socket.
Screws: M3xthickness. I used 8mm.
Anyway, enjoy the model. It requires a few short M3 screws that go right into the plastic just fine.