Case with lock for ZWO Cameras without cooling
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case to store the ZWO imaging camera without cooling and with the 1.25" nose-piece attached and for cables
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
I used this box for ZWO ASI462. Also, it's can be applied to any camera with the same sizes. Original model was for ASI290MC.
The model was printed with Kobra S1, for the printing I used PETG with X-Y Contour compensation 0.05mm and X-Y Hole Compesation 0.05m, but not sure if this is necessary.
For the ASI462 this has the following properties:
- Inner diameter (where the camera sits): 64mm
- Height (incl. 6mm for foam padding): 76mm
Was added lock with little safety tooth which works fine, but I think the places for fingers can be increased, to make it easier to open.