ChipSHOUTER and PicoEMP CNC Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bracket that mounts in place of a spindle on 3018 style CNC machines, no modification to the CNC is required.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 123
- Wydruki
- 1
- Wyświetlenia
- 1107
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This is made for a CNC 3018 with ~42.5mm diameter spindle. If you have a different diameter please let me know I will happily adjust the model and add it.
Allows for a very flexible Z-axis rough adjustment:
You can insert the bracket into the spindle mount from the top or the bottom
There is about 25mm of play vertically for even more adjustment
You can tighten it on many different spots on ChipSHOUTER itself for even more Z-axis flexibility
Update 2026: Added a bracket for PicoEMP as well - uses the same hardware and also allows sliding PicoEMP up/down for more Z-axis adjustment
Hardware needed:
2x M3 x 16 screws
2x M3 nuts
The ChipSHOUTER clamp is just a little bit (~0.5mm) too short front-to-back so the two screws hold the body firmly in the clamp without leaving marks on the ChipSHOUTER.
The PicoEMP has ~1.25mm gap for the PCB while the PCB is about 1.5-1.6mm thick - you can use the M3 screws to both screw it to the spindle base as well as tighten the PicoEMP PCB.
Printed with no supports, 20% infill. Personally made this with PLA, plenty strong for the use.
Meanwhile I switched to PETG when making the PicoEMP bracket and printed with 0.15mm layers (screw holes are nicer) and 25% infill, no supports needed.