1 / 6
Badge holder for 3rd gen adorable motoring vehicles.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The existing badge holders seem to be made for the 1st/2nd gen. So I made this 3D printable holder.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 425
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
The existing badge holders seem to be made for the 1st/2nd gen. So I made this 3D printable holder. It also has the nice property of not needing to remove the grill to install the holder. Steps to install:
- Buy a badge on Amazon or somesuch, should cost only about $9. Some of the badges are magnetic, but that isn't needed for this holder.
- Print the holder in PETG or ABS (PLA will probably warp over time and doesn't do well with UV). Print frontup with supports on.
- Attach to grill using two quick ties. After the ties are tight rotate them so they are fully recessed in their channel.
- Apply some glue (I used Shoe-Goo) or epoxy to the front of the holder, then push the badge into the recess. Use blue tape to hold the badge until the glue dries.
- If you ever need to remove the badge, there is a slot at the bottom of the holder where you can slip in a screwdriver and turn.
Standard badges should fit, I also made a few designs: https://www.thingiverse.com/thing:3272065
Print instructions
Category: Automotive Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Supports: Yes
Filament: Hatchbox PETG or ABS