1 / 6
Protective jaw caps for Bessey Vacuum Base Vise — zdjęcie 1
1 / 6

Protective jaw caps for Bessey Vacuum Base Vise

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement protective jaw caps for the Bessey Vacuum Base Vise (BVVB / BV-VB) , a.k.a. that lockpicking vise

Ocena
0 / 5
Polubienia
3
Pobrania
14
Wydruki
0
Wyświetlenia
84
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Textured and untextured replacement protective vice jaw caps for Bessey BVVB Vacuum Base Vise (BV-VB). I tried to replicate the stock ones as close as possible for a first iteration, I may tweak the design a bit to remedy some frustrations (caps falling of jaws when rotating the vise) and make some alternate textures in the future. 

Print settings

Since TPU is probably the filament that makes most sense for this, I'd suggest to stick to what works best for you. This was one of my first proper TPU prints, so I'm still feeling it out. That being said, these are the settings I used.

  • Filament: TPU 95A (Creality)

  • Walls: 3

  • Infill: 15% (not that there is much infill to do with 3 walls)

  • Supports: small brim 

As for the support it should be fine without on textured plate with glue but a small brim is easy enough to trim. I printed standing up, that has been giving me the best results for any TPU print.

Changelog

2026-02-26
  • Replaced STL with proper oriented set of jaw caps.

2025-08-22
  • Added the ‘moar grabby’ jaw cap variant that extends the over and under hang legs vs the stock size.

2025-08-20
  • Initial version with non-textured and textured 1:1 size of the original jaw caps.

 

Tagi