100$ foldable Drone (Bugs 3 Shell) Simple Build
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simply buy a Bugs 3 for 100$ and put the electronics into this 3D Printable shell. update 11.01.2019: Reworked the…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 914
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — NoDerivatives
Simply buy a Bugs 3 for 100$ and put the electronics into this 3D Printable shell.
update 11.01.2019: Reworked the Arms
As screws i used black M2x6mm metal self tapping screws. All the fiber rods have a diameter of 6mm and i used 6mm diameter steel balls combined with 5mm diameter springs for all the locking mechanisms. The only parts that need support are: Bottom, Mid, Arm, Arm Reworked and Arm coverplate reworked
For the Leg folding mechanism you are going to need an elastic rope that's thin enough to fit through the inside of your 6mm fiber rods. The two ropes are approximately 20cm long. Use a lighter to gently melt the end of it to seal it.
Foldable Propellers totaly work on the drone as well.
most important of all tho ..
I HOPE YOU WILL HAVE FUN WITH IT :D
Category: 3D Printing