SOVOL SV08 MAX TOOLBOARD COOLING FAN! FULL COVER!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
USE FOR HIGH TEMP PRINTING! Full extruder cover!
- Ocena
- 5 / 5
- Polubienia
- 77
- Pobrania
- 360
- Wydruki
- 5
- Wyświetlenia
- 2683
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you find your toolhead board getting a bit too hot while printing simply add a 3010 24v fan!
Edit: Fixed top so fully flat for better printing!
Edit: Added vented version.
Edit: Added the fan mount here too for ease.
Edit: Totally forgot to upload the fixed original design where the fan was mounted to the cover itself & not the toolhead just like in the original stock blue cover mod that was published. As seen here…
Old stock blue cover mod version
Now you have a choice, mount the fan to the cover or to the toolhead. Select which file you want.
BOM if using the original FAN MOUNTED IN COVER 1.0 version
3010 24v fan
4x M2.5 heat inserts
4x M2.5 6-8mm bolts
BOM if using the FAN MOUNTED ON TOOLHEAD 1.2 versions!
3010 24v fan
4x M2.5 heat inserts
4x M2.5 12mm bolts
2x M3 20mm Countersink bolts
PRINTING
Print ABS/ASA 0.16-0.2mm layer
Print full toolhead upside down on its top with supports where required, it should look like this!
Be sure to add a 0.2mm disc merged with the model here!
Use supports for the fan mount
INSTALL FAN IN COVER VERSION
Install the heat inserts directly into the intake side fan mounting holes. The side WITHOUT the sticker! Then use the bolts to attach the fan to the cover. There is no need for the additional toolhead mount with this version - but it does leave your fan & cover connected to the toolhead board if you used a simple splice into the hotend fan. If thats the case then it's probably better to use the other version or use a different wiring solution.
INSTALL FAN ON TOOLHEAD VERSION
Install the heat inserts directly into the intake side fan mounting holes.
Install the M3 20mm bolts into the fan mount making sure they're flush with the mating surface.
Position the fan in the desired orientation & install the 4x M2.5 12mm bolts through the fan mount & screw into the heat inserts in the fan.
USE BLUE THREAD LOCK FOR STEP BELOW!!!
Add thread lock to the bolts. Offer the fan assembly to the toolboard & put the hex key through the fan blades to tighten the mounting bolts to the board. Be sure to turn each bolt 3-4 turns at a time then do the same for the other bolt until secured.
WIRING!
The easiest solution is to splice into the hotend cooling fan V+ & PWM as there are no other spare fan ports on this board. Other options are available if you wanted some sort of control over the fan but tbh it's really not required. If the hotend is on then you're probably printing so best to have the toolboard fan on too….