1 / 11
6x4.5 Film Frame Scanning Holder — zdjęcie 1
1 / 11

6x4.5 Film Frame Scanning Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Film scanning holder designed to hold 6x4.5 frames on 120 film. Features rollers which allow for smooth feeding of film.

Ocena
5 / 5
Polubienia
20
Pobrania
83
Wydruki
0
Wyświetlenia
940
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

I really like RODSGEAR's 35mm film holder but I wanted a similar version for 6x4.5 frames on 120 film so I made this. I tried to keep it similar to the original design but with a few small changes that improved it for me.

A few key points:

  • This is ONLY FOR 6x4.5 FRAMES.  It does not/cannot use a mask so only 6x4.5 frames will align and fit in the opening properly

  • Extra hardware is still required, though it might be possible to replace some with 3d printed parts

  • This was designed specifically with the Pentax 645N in mind, therefore the lens/camera data that is printed on the edge of each frame is visible in each scan

  • The design in the pictures varies slightly from the final uploaded design due to small improvements I made after printing

  • See the original model for assembly tips

Strictly required hardware:

  • Silicone o-rings:

    • 17mm (outer diameter) / 2.5mm (thickness) – x4

Strongly recommended (but maybe optional)

  • Magnets:

    • 6mm (diameter) by 3mm (thickness) – x2

    • 8mm (diameter) by 2mm (thickness) - x2

    • Glue these magnets into the small holes on each side of the main base. Super glue should work.

    • You can probably omit these if necessary but you'll need to tape around the base once it's assembled (or something like that)

  • 688zz 8x16x5mm (inside/outside/thickness) bearings - x4

    • Allow for smooth rotation of the rollers

    • Might be able to print a similarly shaped cylinder and press those in then lubricate with PTFE lubricant or something instead. 

      • Haven't tested, no idea if it'd work

  • Brass threaded insert

    • M4 x 6 (or shorter) x 6

    • Matching M4x8 screw to go with it

    • Will need to glue the knob in place instead if this isn't used

 

Two model base versions are included for each side of the base. One includes printed feet and one includes a hole for rubber feet to be placed.

 

Tagi