1 / 3
SOVOL SV08 MAX TOOLBOARD COOLING FAN STOCK COVER MOD! — zdjęcie 1
1 / 3

SOVOL SV08 MAX TOOLBOARD COOLING FAN STOCK COVER MOD!

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improve cooling to the board!

Ocena
0 / 5
Polubienia
26
Pobrania
95
Wydruki
0
Wyświetlenia
1325
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

If you find your toolhead board getting a bit too hot while printing simply add a fan!

 

BOM

3010 24v fan

4x M2.5 heat inserts

4x M2.5 12mm bolts

2x M3 20mm Countersink bolts

 

If you want to reprint the entire cover to fit a fan use this model:

https://www.printables.com/model/1390231-sovol-sv08-max-toolboard-cooling-fan-full-cover

 

PRINTING

Print ABS/ASA 0.16-0.2mm layer 

Use supports for the fan mount - SEE PHOTO

 

INSTALL!

Install the heat inserts directly into the intake side fan mounting holes.

 

Install the M3 20mm bolts into the fan mount making sure they're flush with the mating surface.

 

Position the fan in the desired orientation & install the 4x M2.5 12mm bolts through the fan mount & screw into the heat inserts in the fan.

 

 

USE BLUE THREAD LOCK FOR STEP BELOW!!!

Add thread lock to the bolts. Offer the fan assembly to the toolboard & put the hex key through the fan blades to tighten the mounting bolts to the board. Be sure to turn each bolt 3-4 turns at a time then do the same for the other bolt until secured.

 

Toolhead blue cover

Use the template, place it onto your stock extruder cover & use a pencil to trace round the aperture, then use a Dremel cutting disc to cut out along the pencil lines.

Now super glue or E6000 the fan mount itself in place - it helps to have the fan installed also!

 

WIRING!

The easiest solution splice into the hotend cooling fan V+ & PWM as there are no other spare fan ports on this board. Other options are available if you wanted some sort of control over the fan but tbh it's really not required. If the hotend is on then you're probably printing so best to have the toolboard fan on too….