BigTreeTech SFS 2.0 Ender 6 Extruder Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for BTT SFS V2 filament sensor on a direct drive Ender 6 utilizing the extruder's old mounting surface.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I modified my Ender 6 to direct drive, and when adding an SFS v2 I wasn't happy with the positioning. It was too close to the case, and my TPU prints would frequently pull the filament off the spool, resulting in tangles.
This mount attaches to the surface previously occupied by the extruder, perpendicular to the surface so as to pull from the filament closer to the middle of the spool. It is designed to use with the extruder's original mounting surface, allowing the sensors cable to pass through the already present hole.